Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there way to configure the Firepower 2100 as NGIPS in HA. We need to deploy FPR 2140 without making any routing changes in adjacent devices.
I can see the options only for Routed/Transparent Mode .
Hi Friends, I have ASA 5520 with dual ISP .Both isp's are terminated in same box.I want to load balance between isp. How to achieve this.I know about static route tracking.My requirement is I need to allow the specific source to sec...
Hi All, Am facing a critical issue with 6509 core switch.The cpu utilization of teh switch is reached 99% often. Am checked the logs and reaveled thta debug commend is enabled automatically. after issuing the " U all " utilization reduced to n...
Might be ! I couldn't see any FTW module from FXOS cli..also The failover will be in LINA engine ?Basically the device data interface will not have any IP address assignment and will be able to monitor/initiate failover ?
Data sheet for 2100 depicts that there is a FTW network module available for this platform . I am checking with Cisco to identify the appropriate modules.
https://www.cisco.com/c/en/us/products/collateral/security/firepower-ngfw/datasheet-c78-73666...
Hi Marvin,Yes .. exactly . This is what i am looking for .Also i worked in 8300 IPS where i am gonna configure the same features in 2100 . Thanks a lot for your response. Is there difference enabling the Inline Mode in Routed/Transparent mode. I gues...
