Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
This is regarding one of the largest ISE customer. They have installed ISE(with MDM SCCM) for 80K employees across the world . They had faced lot of issues on ISE 2.4 image and with lot of BU efforts, have been drilled down to couple of bu...
Hi Team,
One of the customer is looking for the 802.1x authentication in a wired network with location based restriction. Customer would like to achieve location based authentication based upon the switch Id & may be port ID attributes.
I would l...
Hi Mike, First of all, thanks a lot for looking into the same. Really appreciate it!This would lead to further question as customer has lot of modular access chassis with 10 slots populated. One single chassis could serve multiple floors in the build...
We are hiting an internal bug. Either we have to wait for next interim release in which it would be resolved is 8.1(1.104). The workaround would be to take the captures from the command line interface or dowgrade the ASA to 8.0(4.6) or greater then...
It all depends upon amount of the traffic. If the traffic between the outside and the dmz interface is more than b/w the inside and dmz then it would be better to put the interface on that bus where the inside interface is located otherwise on put th...
