Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have this issue that I got the error code F0864.I have read that the workaround is to unplug the IO module and plug it in again and then do an reset (reboot) of the IO module!?I wonder if I can do this without any interrupt to the environment ?I ...
HiI gets this faults when I associate a new blade or boots a blade in one of my UCS Chassis: <faultInst ack="no" cause="thermal-problem" changeSet="" code="F0411" created="2013-05-24T08:11:52" descr="Thermal condition on chassis 3 cause:Local IOM:IOM...
HiI have some issues after migrate from CX4 SAN to VNX SAN. Everything is moved from CX4 to VNX and I have disabled FC Uplink port that is connected to CX4. Both my FI's is only connected to VNX.We want SAN boot on our ESXi host, and some of them is ...
HiI wonder if there is any setting to set to get a graceful restart, when I update Host Firmware on a Service Profile and select "Reboot now" under Pending Activities. It seems that it just kill the server.Hopefully it is possible to set it to restar...
HiI'm upgrading my UCS to version 2.0.3c, and everything is working fine.But when I upgraded the first FI, I got this Major Fault:I don't dare to upgrade the second FI, before I fix this error.I have seen that this certificate has to do with secure c...
HiAfter we got these issues, we have decided that we are going back to local disk.Have local disk in all host now, so I think that's the way we solved it.
Hi.This started after I put 3 new servers in slot 6 - 8 in this chassis.Blade number 6 seems not to work as it should, because I can't connect to any network from this server, but the other new servers have no problems.So I think that this server may...
