Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have Vocera and Spectralink successfully working within a LWAP environment running version 4.2.176.0. This will be my 1st deployment in implementing both vendors together. The Vocera badges are the largest of the two with only a handful ...
Does anyone have Vocera and Spectralink working succesfully on the Same WLC version 4.2.176.0 This will be my 1st deployment in implementing both vendors together. The Vocera is largest of the two with only a handful of spectralink phones. One of my ...
Has anyone on the forum successfully configured wpa/wpa2 with psk on the nortel wireless ip phones model 2212. If so, what psk key type did you use, ascii or hex?
I just completed an enterprise upgrade of WISM blades and 4400 controllers using 4.2.176.0 code and bootloader code of 4.2.112.0. This was soley based off Cisco online documentation and opening up a TAC case for confirmation. So far it's been over si...
I encountered this issue before and I out found that the lwapp software through the corporate firewall was getting stripped. I proceed to download the same lwapp update image via cable modem and the problem was gone.
You probobably encountered the error because there's actually a seperate version for the 2106. See the link to download the code?http://www.cisco.com/cgi-bin/tablebuild.pl/2100_series_Wireless_LAN_controller
Go ahead and delete it..write erase as well and reload...should work fine. Also make sure your switch port is configured as an access point for the respective vlan.
