Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have just migrated our Windows 7 x64 SP1 machines from the Cisco IPSec client to Cisco Anyconnect 3.1.02x.Users have immediately noticed the negative effect that the AnyConnect client upgrade has had on their machines - Adding an additional ~20 s...
Has anyone else found that by using NAM it dramatically affects Computer Boot Time? My investigations have shown that the NAM service takes ~160 seconds on average to start up!I wish to use NAM only to control access to WiFi. in the NAM policy I hav...
Bit of an update here,I have removed SBL and DART from a couple of test machines. It sped up the boot time, but only by a few seconds.It seems that the Network Access Manager is the problem - It is taking over 164 SECONDS to startup! We use Network ...
I haven't tested with Anyconnect 3.0. Is there a particular reason that I should?Good point re: the modules. The modules that I have installed (beliving that this would represent a fairly standard install) are:Base Windows ClientNetwork Access Manag...
Did you ever figure out what was causing this issue? We have just migrated to Cisco Anyconnect from the old Cisco VPN client and are receiving reports that when connected to VPN Outlook continually asks for the username and password. No matter what ...
