About liubo0001

liubo0001 · 06-13-2013

Hi, Env: Configured Cat3560's L3 port and vlan port, enable OSPF routing, SNMP server, etc. The routing info can be shown by CLI show ip route. But, using SNMP MIB broswer to read IpRouteTable(OID.1.3.6.1.2.1.4.21.1, MIB-II, RFC1213), nothing returne...

liubo0001 · 06-18-2013

Hi, Steve, Okay.But it's strange, on the IPBase licensed switch, OSPF can be enabled, and ip route table can be showed by command line, just in the SNMP IpRouteTable is empty.Thanks for your answer.Tony

liubo0001 · 06-17-2013

Hi, Steve, You can see more image info below, if it's license issue?Thanks for your promoted answer.Tony-------------------------------------------------------------------------------------------------------------------------------------------------...

liubo0001 · 06-16-2013

Hi, Steve, I have tried IP-FORWARD-MIB(1.3.6.1.2.1.4.24), nothing retured, no value there. It seems Cat3560 doesn't implement this mib.Tony

liubo0001 · 06-16-2013

Hi, Paul, The running image is:Cisco IOS Software, C3560E Software (C3560E-UNIVERSALK9-M), Version 12.2(55)SE3, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2011 by Cisco Systems, Inc.Compiled Thu 05-May...

Member Since	‎06-13-2013 07:54 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	5

User Statistics

User Activity

Cat3560's SNMP IpRouteTable is empty?

Cat3560's SNMP IpRouteTable is empty?

Cat3560's SNMP IpRouteTable is empty?

Cat3560's SNMP IpRouteTable is empty?

Cat3560's SNMP IpRouteTable is empty?