Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 5510 with an inside network, outside network and DMZ network.Right now, they are all able to communicate fine. But I have to add a another VLAN to the inside network, and have it be able to communicate with the DMZ and outside network....
I'm currently working on setting up 2 ASA 5510's with redundancy/failover. I'm not an expert when it comes to the ASA's so I'm not 100% sure if I can do what I need to.I have 2 inside networks that need to remain separate, a DMZ network,and an outsid...
I just got a Cisco 2960G 24-port gigabit switch so that our HP servers can have a Gigabit connection to the network. I moved 2 servers to it (HP Proliant DL380's) but they don't actually seem to be able to achieve even close to 1000Gbps. I ran same ...
No. I have no QoS configured on those ports. Here is the port configuration:interface GigabitEthernet1/0/18 switchport access vlan 100 no logging event link-status speed 1000 duplex full no snmp trap link-status spanning-tree portfastend!interface G...
