Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Dear All.We have typical deployment with WLC550x (7.0.116.0) and 16 APs (AIR-LAP1242G-E-K9) placed on same site. WLC connected to 3560 (with LAG , and dhcp relay) , and all wireless clients( Motorolla MC3100 handled PC ) work with same WPA2-...
We have standart wireless deployment with 24 APs (1240G model) and wireless controller 4402-25 placed on same site.Most of clients (WMS RF terminals ) works with one WLAN (WPA2-PSK) and constantly roam over warehouse , and that works great.But fo...
Thank you for advice and sharing your experience .But cost also matters AIR-ANT2544V4M-R GPL 799 USD this is comparable with AP cost. We wont plan 802.11a or even 802.11n using , and I dont see(or understand) any reasons to use dual band ...
Same problem. By EOS EOL Notice 1602 or 2602 are suggested replacement for 1242 series APs http://www.cisco.com/en/US/prod/collateral/wireless/ps5678/ps6521/end_of_life_notice_c51-726425.htmlWe used 1242G in our warehouse only with one omnidirectio...
Problem resolved by correcting design. I'd remove wlc interfaces from wlans . And now system work almost flawlesslySent from Cisco Technical Support iPhone App
Definitely this problem related with HREAP. Proved that disabling local switching for WLAN resolve problem.I think this is may be design error ,because WLC interfaces and APs placed in same broadcasts domains. That definitely is not typicall ...
After disabling local switching and auth for WLAN, WLC work without %APF-4-EGISTER_IPADD_ON_MSCB_FAILED error more than 24 hours and client didnt receive duplicated address errors . This wont prove anything but usually error occure earlier. I will ...
