Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hallo
We had a active/active Cluster and the primary unit crashed and must be replaced.
The secondary is up and running.
The config on the active looks like : ( Failover is already deactived )
ffm-sep-dc/sec/actNoFailover# sh run | grep fail
no fa...
Hi
We are using the CSM ticketing System and also we have an external ticket System from HP now.
Before we had ASSYST as external ticket System and it was possible from CSM to jump direct to the ticket at ASSYST
Now we have HP Service Manager and t...
hiVersion 9.1I configured my "admin" context to transparent and the "Firewall" context to routed.It was my fault. "admin" context should be routed and "Firewall" transparent. via Command line changing "fiewall" context to transparent was working bu...
Dear all,We want to test now the Cisco ASA NGFW and therefore I have to convert the 5515 Firewall .What I have is a SSD Card ? What are the steps now ?( putting the SSD in the fw and then re-Imaging ? How , Need a IPS License , Loading IPS SW etc.) ...
-Do not, under any circumstances, type in "no failover".-
Can you explain in depth which Firewall Needs a "no Failover" or "failover" now , pls ?
At the moment the active seonday has a "no Failover"
but , how to I get application functionality than ?do I Need the CX module for that ? If yes, either IPS can running or application control , right ? What to do to have both IPS and Application control parallel ?
Confusing - what I want is IPS and application control on my ASA-X nothing more .What I find out is:I have a CX module ( see attach) this allows application controlFor IPS funktionality I Need the Firepower ModuleThat´s right ?But only one module is ...
