Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Unit keeps going through cycles as shown in index 1 to 7 in the attached file. From removing client to changing radio state back to up. Anyone have any thoughts at to where I should look?
I have DHCP enabled yet it is not responding to any DHCP requests.Most of our clients have static addresses, but we did set the RV082 up to assign a few addresses for when we have visitors.Am I missing a setting?Paul
I have replaced an older linksys besfx41 router with a RV082. Enabled DHCP. Gave it a range of addresses to use, gave it DNS addresses but it will not give out addresses.Anyone have any thoughts?Paul
QuickVPN 1.4.0.5, RV082 2.0.0.19I am having no problems with this router using Thegreenbow client. However, having no success with the QuickVPN client.When trying to connect from my laptop remotely using QuickVPN I am seeing:ConnectingActivating Poli...
Karla,Thanks for your response.The root side has always been set to root bridge. We have been running WPA as we are in a small town in the country and do not have a radius server running. My thought to change to WEP at this point, if that is not the...
Rasika,Following are the Root and Non-Root "running-config" reports. (encription keys have been modified)FROM ROOT Cisco_bridge_CCS#show running-configBuilding configuration...Current configuration : 2446 bytes!! Last configuration change at 07:44:23...
Thanks for the input.Turned out to be a rogue DHCP server. Had been there for years, but only created a problem now that the we replaced a Linksys B series with the RV082.Paul
jagor,Life is good! That did it! Many thanks.Another quick question on certificates. Do I have to recreate after a user is added, or is the first one I generated good for all new users?Paul
