Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Under the 2.4ghz status I see:Transmitter Power errorWhich i believe is the culprit for weak wireless and also choppy connection to AP.attached is configAlso I'm using cisco power injector which says its non-cisco which it is!!Help guys no one in cis...
the AP is working just fine, and the show cdp neighbors shows zero device ID.it is fine, everything is working just fine, radios are up! just that errorThanks for info!
So i ran command:ap(config)#power inline negotiation injector installedError: Command failed. No MAC address detected. Is CDP enabled?I don't know the MAC of the injector as i'm not physically There, do I have to have the MAC address of the injector?
I did everything upgraded firmware etc..The issue is it is working fine but the Error message is because it cant see the Injector and says its a NON-CISCO which of course it is and labeled on the injector it is a ciscobut everything is workingi guess...
