Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I recently set up an IPSEC VPN between two routers, I used loopback interfaces as the two peers, but I had to configure PBR in order for the the tunnel to work. Do I have to always configure PBR when using loopbacks in IPSEC? if so then why won't ...
Hi folks,I've got a questiong about ACL hashing on routers and ASAs, on the router I can use the command:ip access-list logging hash-generationAnd as far as I understand the ASA generates a hash for its ACLs by default, is this true? is there some eq...
I'll make sure to try again, because I read on several places online that if you route traffic into the loopback (in order for it to hit the crypto-map) with a regular static route, the traffic fails and so it did. but when i did it with PBR and "set...
