Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I need some advice on the authentication of my switches.I have a network set up where every switch uses telnet only for the transport input method. I need this to change to SSHv2 only.I also have a RADIUS server backing off to Active Directory...
Hi all,Thanks for your feedback. I have Cisco ISE being deployed within the next couple of months so hopefully that will help to solve this problem. I'll wait until then to start configuring it.Thank you for your replies, this has been very helpful.S...
Hi Javier!No unfortunately I don't have ACS at my disposal; I have only a RADUIS server. I currently have some Wireless LAN Controllers authenticating clients on RADIUS and I was told that it can authenticate users going into Privileged EXEC (Enable)...
