About TheAlteredMG

TheAlteredMG · 03-11-2021

Dear Cisco community Recently I set up a vPC Cluster with two Nexus 5548P both incl. the L3 Daughter Card.I have 3 SVI's (VLAN's 10-13) setup on the Nexus with IP-Addresses configured and on which the Nexus is reachable from my Laptop with both ssh a...

TheAlteredMG · 03-15-2021

Hi Rick Please excuse me if I haven't elaborated the issue clearly enough an let me rephrase. Indeed nearly all communication path are working in the network except traffic destined to any VLAN interface on the C3560 with a source other than the same...

TheAlteredMG · 03-15-2021

The Route-Table is empty as I'm not doing any Routing on the C3560. Default gateway is not set Host Gateway Last Use Total Uses Interface ICMP redirect cache is empty

TheAlteredMG · 03-15-2021

Here you go:Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator M - not in...

TheAlteredMG · 03-15-2021

Hi Rick The 3560 is connected via PortChannel (Po2 configured on C3560, Po500 configured on NX). On that Po and any other physical interface associated to it its a trunk allowing VLAN's 10-12. show interface status:Port Name Status...

TheAlteredMG · 03-15-2021

Hi Paul I'm not doing any routing on the C3560 (Please see illustration below). Also I'd like to have a VLAN int for all the VLAN's in order to work with IP-helper and Management Traffic. Best regards,Marlon

Member Since	‎02-26-2014 08:31 AM
Date Last Visited	‎03-19-2021 12:01 AM
Posts	8
Total Helpful Votes Received	10

User Statistics

User Activity

SVI unreachable through vPC Port-Channel

Re: SVI unreachable through vPC Port-Channel

Re: SVI unreachable through vPC Port-Channel

Re: SVI unreachable through vPC Port-Channel

Re: SVI unreachable through vPC Port-Channel

Re: SVI unreachable through vPC Port-Channel