Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently acquired a new PTP service upgrade (ethernet) . We are still using our old one PTP 1.5mb connection on our serial interface. I purchased and installed the new GB ethernet interface to compensate for the increase in bandwidth provided by t...
I have 3 1941 Routers with IOS version 15.1(4)M3(MD). I noticed that the latest releases are into the 15.5's but the stable recommended ones are 15.4's. My question is that are there any pre-req's or suggested upgrades paths before getting 15.3.3M5(M...
Hi Everyone,I've been working with our companies' 2 Cisco Router's for about 1 1/2 years now and i've come across one issue i havent been able to remedy or find a viable solution for short of purchasing 1 model or 2 up. Our 2 Cisco routers handle our...
Hi Cisco Family, I have a question about Cisco Router/Switch Interface IP changes. This router is used exclusivly for our VoIP network only. Keep in mind i tried to find specific documentation on the results/effects of this action but couldnt find no...
Hi Cisco Community,I have a question about iOS upgrades for our Cisco 1941 routers. The model spec is Cisco 1941/K9 and we currently are running iOS version 15.1(4)M3.I know the most recent release is 15.4.1T1(ED), yet one thing i remember from my pr...
Paul,Finally found cause of issue. The ethernet PTP is set for specific vlan. Putting in change order to set it to untagged which is what my old PTP T1 was. I'll let you know how it turns out.
As for the arp table and the ip from the other side of the PTP it says incomplete for hardware address and the interface is blank. This is whoever the result of not using the default interface. I acquired this by simply turning the interfaces off the...
