Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a number of ASA 5505 boxes which I need to reconfigure to work with a Watchguard XTM 850 over IPsec. The 5505s were previously configured to connect back to a 5510 Firewall using EasyVPN. With EasyVPN still enabled, the remote boxes attempt ...
Our office has a number of remote employees that use ASA 5505 boxes to access resources and connect their IP phones to our office. These boxes all connect through a pair of redundant ASA 5510 firewalls. When we configure these 5505 boxes, we used t...
Let me start by saying i'm Cisco challenged. I understand all of what i'm doing, and i've done it before with HP switches, but i don't have much experience with Cisco, and I think i'm making it more complicated than it needs to be. Let me start by ...
I have an HA pair of 5510's that are way behind on updates. They currently only have 256 MB of memory, so I am considering the upgrade path below. Does anyone see any issues with this? is there anything with my current config that may not work cor...
Perhaps I didn't explain my problem very well. All of our remote ASAs are working fine. The issue I have is I need to be able to test new ASA boxes before I send them out. The only network I have available in our office now is the inside side of o...
Yes, that's exactly what i'm trying to do. I'll go ahead and post another thread in the firewall forum. Thanks again for all your help, you definitely helped point me in the right direction on all of this.
Looks like you were right about the static NAT. I found it and removed it, but that still didn't cut off access to one of my internal subnets, and after spending a couple hours looking I still couldn't find it. I ended up writing the rules to allow...
OK, so i've made some progress on this. I was able to set up the VLANs on all my switches, and get the DHCP working from my ASA. The last issue i'm running into has to do with the firewall settings. I want this new VLAN to have unrestricted access...
Thank you very much for the help. Sounds like the route I need to go is trunking the AP to 2950 connection, the 2950 to 4510, and the 4510 to ASA, then adding the sub interface on the ASA. I read something earlier this week about adding a sub inter...
