Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I wonder if it is possible to limit the data rate (bandwidth) on a single port in SG500-28 switch? If yes how can I do it. A thorough description would be useful.Thanks in advance
Hi,I am see the following error in the system log of my SG 500 Cisco switch:%IPADTBL-N-IPDUPLICATE: Duplicate IP address 192.168.0.1 from MAC 00:xx:xx:12:43:2e was detected on VLAN 200, port gi1/26, aggregated (4) When this error occurs, the PC conne...
Hi,First of all, this is my first post in here, I hope someone can help me, and please be patient since I am very little experienced.OK, so let me explain you the scenarion that I am facing and hopefully someone will be able to help me.We have a Cisc...
Any ide why am I getting "Duplicate IP address 192.168.0.1 from MAC 00:1a:8c:xx:xx:xx was detected on VLAN 200, port gi1/26" ; This MAC address belongs to the interface for VLAN 200 on my Sophos router/firewall.
Hi again Nagaraja,How can I achieve "you need to configure a default route, next hop address pointing to the Sophos interface IP address."The web interface does not allow me to check/uncheck and change the current routes, pls check attachmentThanks,D
Hi Tom, My ip for VLAN 200 (where the Wifi access point is connected) is: 192.168.0.1I creted one netwrok pool according to that: it is in the attachment, can you confirm if it is OK?Now I want to isolate the devices connected to VLAN 200, not to be ...
I just want to report back for an issue that I encountered.My current port configuration is as follows:port 13 - access - VLAN 200port 26 - trunk - tagged member VLAN200, untagged member VLAN 1 (default VLAN)The switch is router mode.This setup would...
