I am configuring VLANS on 2960x switches by building. We have about 15 buildings and would like to have each building be in its own VLAN. This issue I am having is that we have some devices that are static IP's and when those devices are pluge...
This is how it looks now: 2960interface GigabitEthernet1/0/52 -- port to 4506 switchport mode trunkinterface GigabitEthernet1/0/13 -- Port of the 10.20. device switchport access vlan 140 switchport mode access spanning-tree portfast 4506:interface...
Routing is enabled on the 4506. The above example was from the 4506: 4506(config-if)#switchport trunk ? allowed Set allowed VLAN characteristics when interface is in trunking mode native Set trunking native characteristics when interface is in...
Dont i need the swichport access command?I do not have the switch port encapsulation command : 4506(config-if)#switchport trunk ? allowed Set allowed VLAN characteristics when interface is in trunking mode native Set trunking native characteris...
There will be a dhcp scope for every building. Vlan 55 has one scope. The printers and 10.20 addresses are static not dhcp. The link between the 2960 and the 4506 is configured as a trunk. If I configure the port that a 10.20 address is plugged ...
The 2960 is set up with all ports in vlan 55 and the link back to the 4506 is a trunk port. The 4506 port is set up the same. 4506 interface Vlan55 ip address 10.55.1.1 255.255.255.0Port to 2960interface GigabitEthernet2/10 switchport access vlan 5...