Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Can you try configuring the autonomous system on the same line as eigrp as address-family ipv4 Example,router eigrp 100address-family ipv4 vrf admin autonomous-system 1
Can you share the topology diagram and switch config.You may be missing certain config. Basic troubleshooting steps:Ping the vlan 1 ip from Vlan 1 device.Repeat the same for vlan 2.If not able to ,then check vlan interface is up or not.
