Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3850 switch stack and 1602i Lightweight access points. I setup the APs to join the switch via the DNS entry. When I access the 3850 GUI and go to the wireless controller to change the APs configs such as the names of the APs or their IPs, th...
I have a 3850 switch stack and 1602i Lightweight access points. I setup the APs to join the switch via the DNS entry. When I access the 3850 GUI and go to the wireless controller to change the APs configs such as the names of the APs or their IPs, th...
I have a 3850 switch stack and 1602i Lightweight access points. I setup the APs to join the switch via the DNS entry. When I access the 3850 GUI and go to the wireless controller to change the APs configs such as the names of the APs or their IPs, th...
I have set the AP name from the 3850 CLI and Web GUI. In each case it sticks for about a minute and then reverts back to AP+MAC address. Same with the static IPs -- on that one I finially made a reservation on the DHCP server.
