About JIMYSPEED

JIMYSPEED · 03-18-2019

Hello Guys Need your help putting this to work.Currently i have 3 location with the same specific vender networks with router-Firewall(DMZ)-L3(whith HSRP)-L2SwitchesThe board decided that we should have all locations connected together. They hire an ...

JIMYSPEED · 04-03-2014

Hello Guys i need a little helpI have configured several ASA 5505 some years ago, now it has fall into my lap an ASA 5515 with the the version 9.1 Bellow you can find my current setup, can any one check if there is something wrong with it. From the f...

JIMYSPEED · 04-17-2014

Above you can find a sample of my current config, the only difference is that the real one has 100 times more rules, and of course the NAT was changed according to jmattbullen example

JIMYSPEED · 04-10-2014

Yes mfernan91It did work Regards

JIMYSPEED · 04-10-2014

Hey guys sorry for the late response. jmattbullen the problem was that i was using the nat ip instead of the real ip my bad.And also i had to clear the ARP table from the swtiches connected to the outside and inside interfaces because they still had...

JIMYSPEED · 04-07-2014

jmattbullen With that packet tracer command this is the output:Phase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit RuleAdditional Information: Forward Flow based lookup yields rule: in id=0x7fff2a639130, priority=1, domain=permit, deny=fal...

JIMYSPEED · 04-04-2014

When o made the test i made it with the correct rules in the inside and not using the current rules.Even if all the rules are in place, in the syslog messages from the ASDM i am only see the teardown of the icmp packages.But i will try what you said....

Member Since	‎04-03-2014 11:48 AM
Date Last Visited	‎03-18-2019 04:11 PM
Posts	9

User Statistics

User Activity

stack and hsrp connected to each other.

Problem in ASA 5515 no traffic (information) passing through

Above you can find a sample

Yes mfernan91It did work

Hey guys sorry for the late

jmattbullen With that packet

When o made the test i made