Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Having followed the guides on site to site VPN and NAT I am very close with this, but suspect a minor error here. It was hard to apply some of the cisco worked examples due to extra complexity here (VLANs, routing to a static IP) as well as du...
Thanks Marius, your responses were much appreciated and helped me concentrate on the right bit. Note to others:The config attached was tested today and is working. If you have the same requirements and hardware as me this will definitely work for you...
Hi All,This is now pretty much resolved, in that the tunnel is up. I will now need to check that the traffic going through it is behaving properly. The error in the configuration related to the VPN settings, everything else was fine. I am sure that i...
Hi Marius,The second config is for the same router as the first one, I just simplified it in case it made things clearer. The Dialer interface IP is static, and was provided by the ISP. It is marked as 81ADDRESS in the show crypto ipsec sa output.Reg...
Hi Marius,Thanks for the response. I don't have any good reason for the 60s timeout, probably an error. The remote end is not a cisco box but it has been tested by lots of other customers - it is used by BT in the UK for over 300 other connections ap...