Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know of any way to remove the F0546 fault code by any other means than squelching all faults with this code?
F0546: fltEthpmIfPortDownNoInfra
Explanation: This fault occurs when a port goes down
Recommended Action: If you see this fault...
ASA5580 running 8.3(1) I think I have a NAT translation issue that I've been banging my head against for a couple of days now. I have an internal server that needs to pass through our ASA firewall and then get's routed to a B2B partner's routers (lo...
We have an SNMPv3 implementation that has been working for us for the past couple of years:snmp-server user ncm NCM v3 auth md5 <myauthpass> priv aes 128 <myprivpass>snmp-server group NCM v3 auth read snmpview write snmpview notify *tv.FFFFFFFF.FFFFF...
I'm determining that the NAT isn't happening from a multitude of sources:First is the firewall log:10 2014/04/29 09:22:35.057 CDT 172.17.65.20 Apr 29 2014 09:22:35 hqpublicdmzfw : %ASA-6-302013: Built outbound TCP connection 163956188 for b2b_dmz:169...
Our firewall administrator has an any,any static NAT at the end of the NAT list. My understanding is that those manual entries are Section 1 & the auto-nat statements are Section 2. Since any translation would match that any/any in Section 1, the a...
Yes, when I originally entered the NAT statement it was after an any,any statement, and I would see the any/any NAT statement hit in the packet-tracer. The NAT statement is now the first statement (using the command as you've shown) and it's still n...
The output requested is below. As you can see in the portion I've shown in red, the step hits the NAT translation rule, but then does not translate. I have injected traffic from the b2b_dmz into the inside and that IS successfully translated. show ...
