Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everybody,Hoping someone can help me with this, if bpdu filter is applied on both ends of an ether channel trunk connecting stacked switches between two locations will stp still see the etherchannel as a single link ? will it result in loops ? ...
How can i find the object-group or object-groups an ip address belongs to/is part of in an ASA running conf ?eg. sh run | i ip address or sh run object-group | i <ip add> gives me the below outputnetwork-object <ip add>network-object <ip add>network...
Issue resolved by using "on" instead of lacp...it seems lacp has some issues in this scenario...irrespective of whatever configs i be tried one of the links was not playing ball and ended up as an isolated link causing the loops...changed the mode fr...
Hmm...i have described my scenario in the new post below, what we have is 2 lanlinks bundled into a etherchannel and loops are seen happening when both links are up, have a look at the below when possiblehttps://supportforums.cisco.com/discussion/123...
Thanks Milan, sorry if i was not clear, what i meant was a scenario where an ether channel is configured and the bpdufilter is applied on the etherchannel (which would mean both physical links would then have bpdu filter on them) what would be the b...
A single link between the sites and bpdu filter enabled on them works fine, but what is we have 2 links bundled into an etherchannel with bpdu filter enabled ? will that cause loops ?Regards,Shiva
