Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
I have a public IP address that needs to communicate with a private IP address behind our ASA via port 444. I have tried to set up NAT to translate from the inside to the outside and vice versa using tcp port 444. Is there somethini...
Hello Everyone,
I am working with an ASA 5508. I am trying to pass a /27 subnet coming from a 2811 into the ASA then out of one interface to a 2960 where a vlan will distribute the network to about half a dozen servers.
A simple illitstation o...
Hello, I am currently trying to design a solution for the following example. I have two groups of Billing servers. A Primary group and a back up group. These groups are also in different locations, at each location I have an ASA 5508-X in front of th...
Radius was working correctly on this router. using this command aaa authentication login default group RadiusGrp local I then addedaaa authentication login default group RadiusGrp line local Thinking this would allow access to the device if the radi...
I am using free radius on ubuntu 12.04 LTS. The AAA configs I have, I used on all of my Layer 2 devices, and it works successfully, however I can not get users to authenticate on a Layer 3 device.... here is some info... I can ping to and from my se...
Jon,
Will I need to do any additional routing on the ASA between the interfaces for example having the /30 point at the /28 (server subnet)
Thanks again.
Ah right, that makes sense. Unfortunately I will need to set up a VPN in the future off of this device so I think transparent mode is out of the question. However you make a great point breaking up the subnet. I was thinking about that at first but w...
