Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using OS Code: 9.10(1)27When I do show access-list it gives me output with ACLs having object-groups in source and destination however under that it also list the IPs covered under that object group. I do not want that detailed listing and only the A...
I have Firepower 2110, I logged into the ASA sitting on top of FXOS using connect asa command and did a reload. After issuing the reload the FPR Chassis also restarted, why is that so because my understanding was that Firepower Chassia and ASA OS are...
I have ASA OS 9.8(2), FXOS 2.2(2.52) and I am trying to configure etherchannel based on the documentation
https://www.cisco.com/c/en/us/td/docs/security/asa/asa98/configuration/general/asa-98-general-config/interface-echannel.html#ID-2077-0000001f
Ho...
Hi,
I have a Firepower 2110 device with ASA OS 9.8(2) and FXOS 2.2(2.52).
The datasheet says that this device has 12 Ethernet ports and 4 1G SFP maximum and I want to know which ports are Ethernet and which are SFP. When I do show interface it gives ...
I have a firepower chassis running an ASA OS code which has 3 used interfaces right now. From the Firepower chassis I want to add another data interface so the total on ASA OS becomes 4.
My question is, after I add the data interface to a running A...
That's what I am doing , get output from show access-list | incl domain , copy in notepad and remove the undesired parts. Thought there might be a automated workaround for this.
2 Reasons1 ) I want to filter out all ACLs with DNS and when I tried "sh run | incl access-list | incl domain" it does not work as expected.2 ) I also want to see hit counts on ACLs which "show run" does not shows.
I dont think its clear
Step 3 Unallocate a data interface by de-selecting the interface in the Data Ports area.
Step 4 Allocate a new data interface by selecting the interface in the Data Ports area.
Step 5 Replace the management or eventing ...
I don't see an option to "2) Turn on Send Email in the report template" . I am using OS 6, Please find below image which is output of new template. I have checked the advanced tab also, also the below icons but they are all related to add a piechart,...
Thankyou. So this is the manual way to do it, open report template, generate report and put email address which is working in my case. Note that the email input is not given to the report template but is provided only when the report is being generat...
