Firepower 2110 EtherChannel

[ring zer0]

I have ASA OS 9.8(2), FXOS 2.2(2.52) and I am trying to configure etherchannel based on the documentation

https://www.cisco.com/c/en/us/td/docs/security/asa/asa98/configuration/general/asa-98-general-config/interface-echannel.html#ID-2077-0000001f

However I am not able to apply channel-group commands under the interface. Checked the other interfaces and its same there (16 interfaces in Firepower 2110)

ASA-FPR(config)# int e1/1
ASA-FPR(config-if)# channel?
ERROR: % Unrecognized command
ASA-FPR(config-if)# channel-group?
ERROR: % Unrecognized command
ASA-FPR(config-if)# lacp ?
ERROR: % Unrecognized command

[Jewgeni Uschegow · Accepted solution]

Hi,

I hope it will be helpful:

https://www.cisco.com/c/en/us/td/docs/security/firepower/fxos/fxos201/cli-config/b_CLI_ConfigGuide_FXOS_201/interface_management.html

Best regards