Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,
Our problem seems strange , we have 2x 6807 Core Switches configured as VSS and mix of Edge Switches Juniper EX3200 and Cisco C2960X connected to Core Switches through trunk links.
One of Our ESX Servers - hosting multiple virtual machines - ...
Hi All,
In VSS , I know that VSL is recommended to be 2 links at minimum and may be in different modules . Can we make both VSL Links in different modules where the sup engine is not one of them ??
We have a new VSS installation and the X2 interface ...
EGCOCSW#sh run int Te1/1/7Building configuration...Current configuration : 108 bytes!interface TenGigabitEthernet1/1/7 description EX3200-SW-51 switchport switchport mode trunkend
all trunk interfaces in both core switches to Juniper or Cisco edge sw...
Hi John,
only arp of the pingable servers appear , other servers not appear.
i have tried to make mac address trace from the core switch and it seems ok , but ping from the juniper not working
from the servers side , not able to ping the juniper swit...
Hi Paul,
Yes other switches cisco or Juniper can ping devices in other Vlans , only the problem in Vlan 226
Due to Security reasons , i will paste only configuration related to the Vlan and trunk interfaces.
Juniper1 (connected to Primary Core can pi...
