About Darren Kruger

Darren Kruger · 05-16-2014

I have setup a mesh network using a Cisco WAC 2504 and a few 1602i access points. I am trying to get ethernet bridging to work but when I connect to the ethernet port on the MAP I am unable to connect out (I am unable to get a DHCP address.) Wirele...

Darren Kruger · 08-24-2014

As per my original post, I have ethernet bridging enabled on both the RAP and on the MAPs and still it does not work. I have seen some references to a possible bug in the firmware so I am going to see if upgrading that does the trick.

Darren Kruger · 05-29-2014

Sorry, I did not see anything new in the link you provided. I had already provisioned one of my access points as a root access point (RAP) and another as a mesh access point (MAP.) I was able to get the wireless mesh part working but use the ethern...

Member Since	‎05-16-2014 06:23 PM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	3

User Statistics

User Activity

Trying to bridge ethernet over a mesh network

As per my original post, I

Sorry, I did not see anything