Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a UC320 with 8 VOIP lines and 2 analogue. It's set to dial out on the SIP trunk first. We want to change the number thats displayed when dialling out via IP - but we can't change it.If I change the 'Account ID' setting, then it doesn't connec...
Could anyone tell me the best configuration for the SG200 switch when used with a UC320.We are hoping to plug the UC320->SG200->Phones->PC plugged into phone.With the UC320 plugged into the switch, the switch picked up a DHCP address from the UC320's...
Update: Still no luck with this. When I create a route for the users DID number and then check the box to use it as the outgoing CLI, then that extension can no longer dial out...
Hi Chris,I'll give that a try when I'm next on-site. I have tried something similar already with no success. Each extension has a DID number - and if I check the box to use the DID for outbound calls, the calls all fail. The SIP provider ran a trace ...
