Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I have an error message when I'm trying to add a service definition (from the Acces rule interface):When I click on the "save" button, the popin say "Critcal failure: please contact support"The service I'm trying to add is the following one:...
Hello everybody,My RV325 contains 4 VLAN, each one with a DHCP server, and most of the clients with a reserved IP.What does mean these log issues?It seems that I have many of them when I set up my RV325 dual wan mode on "Load balance (auto mode)": it...
Hello everybody,I've set up multiples VLAN on my RV325, firmware 1.1.1.06.All of them are managed with DHCP server, sometimes with reserved IP for some MAC address.On one of theses VLANs I would like to set up a 255.255.0.0 subnet mask. Is there a wa...
Hello,I've replaced my old firewall by a RV325 and I'm trying to set up my network configuration on this new firewall.My network is composed of 2 internet access, one server which was in a DMZ, and many devices in the LAN, all connected to two switch...
Hello vreid47362,I'm quite a bit surprised to see that we have both the same idea: provide our feedbacks to cisco to increase our product usage.Here's mine list:Custom services - I was a bit surprised when I have seen for the first time the embedded ...
Marty,Please accept my apologies for the delay of my answer.It seems this is a issue with one of the switch: when I use another switch, everything is fine. Kind regardsDavid
Hello, Please do not take care of my previous answer: I can effectively customise all VLAN configuration including the first one.So I've set up the following configuration: I've set up the following configuration: For now, the wifi acces and VPN VLA...
Hello Marty, First, thanks for your feedback.The problem I have is I'm unable to edit the first one VLAN so I cannot check all them in one time: checked for this VLAN number 1 is grey. For now, I've set my VLAN1 to the default VLAN (with id 1). Do I ...
