Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a situation with a client where two WAP321's are sending out over-sized packets to an SG220 Series POE+ switch. We have tried reducing the WAP's Fragmentation Threshold to 1400 and this has helped some, but there are still oversized packet's ...
I have noticed what might be a small firmware bug. If you go to the Log --> System Statistics page, the Sessions and New Sessions/Sec counters always remain at 0, even with several workers actively online. As a general rule, I find total sessions an...
There are two features I would like to see added to the 300 and 500 series to make them even more useful in small business deployments. 1. The ability for the switches to act as DNS forwarders and to respond with entries in the host table to DNS r...
Hello Cisco Small Business Community. We are a Cisco Select Partner and have started using RV320's and RV325's with our customers. As we are implementing these deployments, I have noticed there are a few features I would like to see added to the p...
Video viewed across the LAN from a client connected to the RV220W's wireless interface is very choppy (both the audio and video portion). If I swap out the RV220W for a different brand of Router and Access Point, the problem goes away completely. S...
It also appears when there is a bunch of LLDP, EEE, and/or possibly CDP traffic on the switch that it seems to get confused and just decides to lock some or all of the ports that have dynamic locking enabled.
It seems the settings built into the macros for Smartports turns on port security and sets dynamic locking on the ports with several of the built-in macros. It appears the port security setting may not be looking at the dynamic hosts portion of the ...
This is a known bug in the firmware. See: https://tools.cisco.com/bugsearch/bug/CSCuu10991/?referring_site=bugquickviewclick
Here's the verbage from the bug description:
Symptom:- WAN port will go inactive intermittently- Following seen in logs su...
We have an RV320 at one of our sites running firmware release 1.2.1.13. The router runs good for about 24 hours after a reboot and then displays the same WAN 1 disconnection issues noted in the thread. We are also seeing the same log messages. In a...
We were troubleshooting wireless access issues in one room of the client's building. Basically, in that particular area, connectivity was bouncing a lot. After we adjusted down the wireless fragmentation size to about 1400 bytes, the connection lev...
