Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Does anyone have the bare minimum procedures for adding a Cisco DTA 271HD to an existing Control System which is already setup for the same DTA devices of the exact same hardware revision, Factory ID and control number registered in the DTA ...
Hello,
I am doing some security research, and am looking into what types of security vulnerabilities or threats a compromised Digital Transport Adapter (DTA) may have on a PowerKey Provisioning system. Set Top Boxes (STBs) or DTAs and CableCARDs ar...
Hello Everyone,Have any of you noticed that the shapes of line cards and port cards are out of proportion with the chassis Visio shape in which you place them. The ones below leave gaps not representative of the actual physical equipment. Also, it ...
I am also including some video frame captures of the DTA's boot up for first time on a provider's network. Maybe someone can explain what his happening behind the scenes in this first time boot-up.
Correct me if I am wrong, but aren't the DTAs a receiving only device? They are a one way only signal reception device and they don't communicate back to the signal provider's network, except for the details about the device, e.g. MAC address and se...
I have been attempting to diagram and document our Catalyst 4506-E switch. All of the option cards were not proportioned properly, leaving gaps between cards. The Catalyst 4500 VSS didn't have the 1400ACV power supply shape. Also, none of the Supe...
