Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just a quick question from a wireless newbie- how likely is it that someone from outside could get into a wireless network with only the following configured? MAC address filtering with 3 specific MAC addresses of wireless devices in use. Changed the...
Just a quick question from a wireless newbie- how likely is it that someone from outside could get into a wireless network with only the following configured?MAC address filtering with 3 specific MAC addresses of wireless devices in use.Changed the d...
I've read that the Aironet 1100 isn't supposed to be a DHCP server. However, I have two laptops with wireless capability and when I turn them on they connect wirelessly and get an IP address in the 169.254.147.x series with no default gateway.Our ne...
Thank you again... as of right now, do all Cisco cards support these specs? I'll be needing three PC cards, and I'm thinking of the Cisco 350 series. We buy from CDW, and the descriptions only talk about 128-bit WEP for security.Ken
So if there's no change to the IP settings on the client (all set to dynamic) and you have no assignment on the DHCP server, it works, but if you assign that MAC address on the DCHP server to a specific IP address, the client can't get the IP address...
Thank you... for MIC and TKIP do I need to have each device running a Cisco-brand Wireless adapter? I have a Dell laptop right now running a Dell-brand wireless adapter that seems to support WEP and EAP.
You were right... there was indeed a problem with the DHCP server. We have it configured with a small pool of addresses and it had simply run out! They were set to 4-day leases which wasn't good... I reset it to 1-day and cleared out the old leases...
Thanks very much for the quick reply. The wireless clients are associating with the AP, as they are displayed in the list in the web-based setup. If I then go and put in a static IP address on the client, it works fine. I did the ipconfig /renew a...
