Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a single ASA firewall protecting a small private developing network, and I need it in order to access remotely to two distinct network spaces both of wich are VLAN tagged: 1 is LAN and 3 is management. Each net has its own IP address space and...
Good afternoon everybody, a few days ago I tried setting up my ASA 5505 to allow access from the outside network to an Exchange server (ports HTTPS and SMTP) in my inside LAN.Everything seems to be working... until my outside IP address changes (for ...
Ok. I got it working using 2 different tunnel groups and selecting them via drop down menu. I'll check in the next days if the "group policy trick" is enough to avoid "kaisaron78" to log into SSL VPN and "manintra" to set up an AnyConnect session. Up...
Ok, it makes sense.Last question then I'll try and report any success / failure. In this Cisco webpage, http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/ref_extserver.html#wp1661512 there's a list of suppo...
Thank you for answering Mr. Latosiewicz,however I'm missing something: do I have to force enable group selection drop down at login and create two different tunnel groups, one for AnyConnect and one for SSLVPN and then assign group policies via radiu...
I finally came to the conclusion that the strange NAT behavior is related to a bug that seems to pop up when you connect using a PPPoE modem instead of a router, so I have chosen to follow your second suggestion Marius.This is the implemented workaro...
I'm getting bored about this issue. It's simply absurd.I tried both your suggestions:using the nat declaration:nat (inside,outside) source dynamic SERVER interface service HTTP HTTPcreates an xlate rule from network 0.0.0.0/0 to 0.0.0.0/0That stateme...
