Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ASA 5525, v. 9.1(5)19Anyconnect client 3.1.02026I have two users who are unable to connect via the AC client or clientless through the web portal. Using the client, it will get stuck in a loop of "checking for updates". On the portal, the connection ...
Have a pair of 5525s in active/standby setup. Standby node shows as failed. If I "reset failover" from the ASDM, it briefly changes to Standby Ready then in a few seconds flips back to "failed". The failover interface shows as Up. No recent updates ...
All of a sudden my AC client seems to hang during the posture assessment: updating portion and after a couple minutes will produce an error: Posture Assessment failed: CSD library signature verification failed. I tried deleting the library from the l...
thanks for your input. sorry for the delay in responding. here is some additional info:*yes, they authenticate successfully.*they connect with un/password*2 users out of about 400*profiles - will check and try to compareRegrettably, due my inexperien...
Thanks for your assistance! I'm not local to the equipment but when I had someone check, that interface was not connected to the switch. As soon as we took care of that, the node status updated to Standby Ready. Appreciate your help.
Thanks for the replies. Below is the show failover, failover history, and failover state from both nodes.******************************************************************************************ACTIVE NODE# show failoverFailover OnFailover unit Prim...
