Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Issue #1:I am having an issue getting my ASA 5505 to hand out DHCP addresses for wireless clients on my home network. Wired clients get an address fine. Issue #2:If I turn off the dhcp on the 'Motorola Surfboard modem SBG6782-AC' the entire n...
Hello, I have an ASA 5505. I am trying to open ports 8100,8200,8300,12778. I am testing these ports are open from telnet: telnet x.x.x.x 8100 etc.It fails to connect. However I can telnet to 80 and 3389 just fine.This is the config line I am usin...
Hello, I have an ASA 5505. I am trying to open ports 8100,8200,8300,12778. I am testing these ports are open from telnet: telnet x.x.x.x 8100 etc.It fails to connect. However I can telnet to 80 and 3389 just fine.This is the config line I am usin...
Hello, I'm new to cisco and need to have these changes made to the vpn tunnel. Can anyone help:
What command would one type to add these configs in. An existing VPN config exists and I am just making some mods:Phase 1 (Isakmp)IKE Mode: Main (not ...
I can't seem to create a static route based on following criteria. Can anyone help? ASA 5505 and VPN tunnel is in play:Interesting Traffic = your single host is trying to talk to our side.Will need to create a static, 1:1 policy NAT of interesting ...
I now see this: ciscoasa(config)# show crypto isakmp sa Active SA: 1 Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 11 IKE Peer: 216.117.40.14 Type : L2L Role : initiator Rekey : ...
Here is the config before your last changes above..when I enter the commands... is there any other command to make them take effect?I'm familar with copy run start to ensure it saves when being rebooted but just curious if there is anything else? I...
