Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been trying to set up dmvpn with the hub behind a nat'ing pix firewall. The setup works fine until I put in the firewall and then it dies. I have the tunnel up but the hub cannot send traffic back to the spoke. The pix has passthru for esp ...
what mechanism would you use in a pair of pix's being used as headend vpn ezyvpn servers in order to have redundancy for ezyvpn clients.... How would the pix's dynamically advertise the routes for the clients they have acquired? The pix's in questi...
We have requirement to provide remote access via both dial and broadband to a secure network inside our business network. This network, SCADA, is separated from the business network by a PIX506. Business users access the SCADA network often using t...
The pix is set up to pass udp500, esp, udp4500. You are right... the tunnels are not up all the time but the isakmp is fairly steady. I have a couple of sites up with p2p gre under ipsec and they work fine. cisco's only examples r with the units di...
good answer since adding gre made no difference. The IPsec and GRE tunnels are built but the ips sa and the eigrp keep going up and down. I cannot send any traffic across the tunnel. It seems that the hub does not really know how tosend the traffi...
thanks for the response. However, the question is not how to configure it on the client but how to tell the current server to advertise the route to the client network.
Thanks for the quick response.All users have access to corp. SCADA users have access to both. All have remote access to the vpn3000 which is outside the SCADA nets but inside the corporate net. As a company policy we do not allow simultaneous acce...
