Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have a question in regards to the Cisco SourceFire. I have a pair of ASA5525x setup for HA. My question is does the SourceFire work as a HA pair or do they operate individually? So far it looks as they are operate individually.
Thanks for...
Hi all,
I have a 5525x and wanted to setup the FirePower that comes with the ASA. I have read and followed the Cisco installation guide, but I am unable to access the FirePower module on the ASA. What I have done;
1. Installed FireSight Mangement ---...
All- I am unable to access my web server from the public. I can access locally if I by pass the FW, I can access as well. Nat and ACLs are in placed. Below is my config; ASA Version 8.3(2)!!interface GigabitEthernet0/0 nameif outside security-level 0...
Marvin,
First of all, thanks for taking your time to reply on this matter.
I dug through Cisco Guide and documentation and found this:
http://www.cisco.com/c/en/us/td/docs/security/firesight/541/virtual-install-guide/FireSIGHT-Virtual-Installation-G...
Marvin,
I still have my 2 ASAs in the lab along with the FireSight management. I'm afraid to register my FireSight management. My question is if I registered the FireSight management license in my lab, will it be a problem when I bring it into prod...
Thank you Marvin for your clarification.
As for the management Center (FireSight), I don't see any documentation on HA. Does it not have HA capability? I ask because NCS (Cisco Prime) has the HA capability.
Thanks in advance.
Alex
I just want to update on the issue. I have placed a test machine on the same network as the SourceFire and I was able to access it. I am still unable to access from other VLAN.
Again, I can access the Firewall from other vlan which is on the same ne...
