Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Did you configure the cluster interface under the L4-7 Device? The configuration has changed a bit from 1.1 to 1.2. You can find it below outlined in red. Please ensure that you have properly configured the cluster interfaces.
If we cannot...
Hey tumarha,
This is a little bit of a change up compared to previous code. Before, you would configure the interfaces (gig0/x and 0/y) as provider/consumer on the device itself and this would put it in for you on the cluster configuration area. Now,...
Hey Ramu,
Here is a pretty good youtube video explaining how it works:
https://www.youtube.com/watch?v=ZvITtE-gQYg
Here is a link to an ACI Fundementals Guide as well:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/aci-f...
Hello, I don't believe we have any way of showing this but I have found an alternative that may work for what you are looking for: http://<APIC IP>/api/node/mo/topology/pod-1/node-101/sys/phys-[eth1/2].json?rsp-subtree-include=fault-records,no-scoped...
