Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey, im trying to route vlan traffic from my 3560 through my 2800 router to my ASA 5520. This Vlan has an IP different from an IP address on a different Vlan. I have two Vlan's setup. SwitchVlan 2: 10.1.1.15 /24Vlan 10: 172.16.10.5 /24I can route tr...
Once again I want to thank everyone for their help. After re-reading all the posts I realized what I was doing wrong. I was going at it the wrong way. I created two trunk ports on my switch and they both connect to my router and ASA. I then created t...
I removed the config because it hadnt worked. This is what I did...I basically matched fa0/21 to fa0/22 with the exception of vlan 20 rather than vlan 10. I even tried using fa0/22 to trunk the router where I had setup a sub-interface pointing to vla...
Here's the config for both my router and ASA as they stand right now. If you need the switch config let me know... Router#sh configUsing 1258 out of 245752 bytes!version 12.3service timestamps debug datetime msecservice timestamps log datetime msecse...
I tried that earlier and it did what I wanted, but it takes away from the ports on the router and switch. On the router im already using both ports to the switch. Would I create a sub-interface on the router under fa0/2? Like fa0/2.xx? I tried that a...
Not sure my edit came through, but Also, what if I want to add another Vlan with a different IP? How would I go about setting that up if I run out of ports on my router and ASA?
