Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I have configured Anyconnect on the Outside interface, and can reach the Inside network. However i cannot reach the other Inside_2 and more inner interfaces on the ASA.Example:
Interface Name IP address Subnet mask MethodGigabitEthernet0/0 Outside...
Hi I have on the router ZBFW applied on all interfaces:zone-pair security IN-TO-OUT source INSIDE destination OUTSIDE service-policy type inspect PM_IN-TO-OUT policy-map type inspect PM_IN-TO-OUT class type inspect CM_IN-TO-OUT inspectclass-map type...
Hi I noticed that reflexive ACL are missing on the 4300 routers ( particularly on the IOS 15.4(3)S2 )The keywords evaluate and reflective are missing there:# permit ip 10.1.1.0 0.0.0.255 any reflect r-out timeout 300% Invalid input detected at '^' ma...
Dear Rissethcan you send the hint how to incorporate the IP INSPECT into the policy map : ?E.g:ip inspect name webfilter http urlfilterip urlfilter exclusive-domain permit .microsoftonline.comip urlfilter exclusive-domain permit .office.com With this...
Hi mark i wanted to do it vice versa, so first i removed the zone member, then configured IP INSPECT, and then wanted to apply back the zone member. However it was not successful:Router(config-subif)#zone-member security INSIDE%Inspect rule is config...
