Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have two ASA5525 in mode failover. Only one them has IP address configuration. For example:!interface GigabitEthernet0/0 description outside nameif outside security-level 0 ip address 71.210.56.231 255.255.255.252 !interface GigabitEthernet0...
Hello,We have two ASA5525 in mode failover. Only one them has IP address configuration. For example:!interface GigabitEthernet0/0 description outside nameif outside security-level 0 ip address 71.210.56.231 255.255.255.252 !interface GigabitEthernet0...
Hello,
Sorry for only one question. When you hace HA configured and working fine, you should access to both? or only to one of then and IP of HA?. That's to say, I have this CPI 3.1
10.0.0.1 == > Active10.0.0.2 == > Standby10.0.0.5 == > HA
Is the n...
Ok then. I'll write the secondary address in the interfaces, but one question more.I understand that the mode (active/active in status Failover) that appear in the output of "show version or show activation-key" commands, It isn't my problem.I want ...
Hello Marvin.I understand the state (waiting) of the interfaces. But with this configuration (without secondary address in no interface), when I unplug the cable (DMZ_Servicios interface) for example , and we have the failover link up/up, I understan...
Hello Marius,Well, I didn't explain correctly. When I told that I put the interface in mode shutdown. I wanted to say that I put in mode shutdown the interface connected to the switch (not in the firewall). It is the same that unplug the cable, but t...
