Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently I replaced my ISP equipment with a Linksys WRT 1900AC wireless router. When I did this I lost connection to my LAP1142 that acts as a repeater. I can assign a static IP address of 10.0.0.3 255.0.0.0 and use the GUI interface, but when I sel...
I am new to this, so please have patience. I purchased an LAP1142N and can't seem to get the Configure Terminal command to work after I enter the "enable" command. I get the "Invalid input detected at '^' marker" error message. I did notice that w...
I followed your steps and even reviewed your webpage (which is very informative). In addition to that I looked up this article http://kb.linksys.com/Linksys/ukp.aspx?pid=82&vw=1&articleid=29317for the proper steps in setting up the 5ghz channel as t...
The SSID on the 1900 is set to WPA2 Personal.I was up rather late last night trying to figure this thing out. After becoming very frustrated with the config, I looked up the directions on your website and reset it to default using the mode button an...
I have played with this config several times and can't seem to get it right. I am trying to configure this LAP1142N as a repeater. It should be noted that I am configuring this 1142N on a laptop via the blue Cisco console cable (for the CLI portio...
Ohhhh very nice! All of my client are 802.11n.I think this is my final question (until I pull cable to the AP)... The LED light seems to change from Green to Blue. I tried to research what the different colors mean, but came up empty. Currently a...
This is for home use. I am trying to extend the range of my network while providing a fast / stable connection. So, VLANS and such are not needed. I will probably pick a small 8 port poe switch. Also, to save this config I type... "copy running-conf...
