Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Im upgrading my FMC FS-2000 from 6.2.2 to 6.2.3, from the documents it should take about 40mins.
Its now been running for 2 hours.
The last thing i can see in status.log from CLI is:ui:[10%] Running script 000_start/400_run_troubleshoot.sh...
...
I have network risk report running on a weekly basis. Normally it takes 1 hour. But now it wont finish. As seen on the attached:
it just stays like that. When im in reporting tab it says its queued. I tried to start another one just to see if it ...
Hi Im having a lot of Switches (900). Many of them has wired connections in most port from the days when it didnt run wifi. Now most of my locations is having wifi, but still most switches has a lot of wired still connected..Is it somehow possible in...
HiIm fidling with these templates. Got some good help in the last one, and some fine input and got that solved. So now im on to the next issue i have.I will make some automation to adding VLAN.Each location i have, has 20 vlan.Location 1 has vlan 20-...
Hi Im trying a bit of templating here, but im having my problems. Dont think the guide for prime gives good enough answers when moving to interactive and more advanced stuff. Where can i find something about that ? Also the problem im having right no...
Just to update and finish this.
The upgrade process was stalled. TAC killed the process, and then it stalled again later on. According to TAC it was because of large events files, and many of them.
We deleted them all, and started the upgrade ag...
Hi Yogesh
Thanks for reply.
The -troubleshoot.tar.gz file is not increasing in size. Its stayed the same all the way. Been stalling for 8 hours now.
I made a TAC case on it. Have got my first reply from them, now im awaiting the next after they g...
Hi..
I have tried to make something that hopefully looks like what you are looking for.
I have made it so you also get a dashboard to look at.
1. Go to Analysis - Custom - Custom Tables
2. Create Custom Table
3. Name it, In Tables choose Connection E...
Thx for reply
I wanted to do this. But this night something have happend that stopped all services (and started them again) So the process reporting has been stopped now, and just tried make a new report and that works now, so guessing it solved ...
