Dear All,
I'm facing a reachability issue when using a switch between my routers. This happened when i disconnect point to point connection between both router (R1 and R2 ).
Internet<-------R1---- --------R2------->customer
...
Hi Rick,
Sorry for the confusion. Since the customer having issue with the reachability issue, i tried to connect direct between R1 and R2 to test. Eventually, it resolved the customer's issue.
So, i have a question that what cause the reachability...
Hi Richard,
I have to shut GigabitEthernet1/0/1 in order to get the trace to work. Once i shut GigabitEthernet1/0/1, i bring up another direct connectivity between R1 and R2 which solve trace issue. I'm not sure whether my design is wrong or i missed...
Hi Richard,
Basically, R1 and R2 is used as upstream router and R3 and R4 will act as edge router. Due to the limited port on R3 and R4, i tried to use switch in between to connect R1 and R2. For the switch portion, i didn't place any config for the...
Hi,
Sorry for delayed response. i'm using 3750 to connect all routers. The below is the config from my switch.
*******Config for SW************
interface GigabitEthernet1/0/1 description 1Gbps Ethernet Link to BR-1 shutdown spanning-tree portfast!in...