Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Introduction
After deploying a new Virtual Firesight Management Center (FMC), the console may display the message "WRITE SAME Failed. Manually Zeroing" after installation.
Q.
Does this message indicate a failure during installation? Should it be c...
All,
Please be advised that changing the time zone from the command line is NOT supported. Doing so will require you to re-image the device to enter back into a supported state.
Thank you,
Justin Roberts
Firepower TAC
