Hi Rasika.  Thank you for helping.I don't think there's a way that I can specify what firmware version it will ship with.  I just chatted with Cisco support and they won't help unless it's under warranty (which it should be since I just bought it).  ...

Hi Rasika.  Thank you for your assistance. After building a cable to go from the RJ-45 console port to a DB-9 serial port so I can see the comms, it turns out that I didn't actually brick it, but because I did a boot manual it was waiting for the con...

Hi Rasika.  Thank you for taking the time to help me with this issue.I'm still having problems trying to get it to boot in autonomous mode.  I wonder if the problem is that the firmware is older (see the attachment on the previous post, it shows vers...

I was able to SSH in and did the debug capwap console cli.AP58f3.9cc4.9df4#debug capwap console cliAnd then didcapwap ap autonomous followed by reload (saving the settings and confirming the reload)I think it was still coming up in CAPWAP mode.  Norm...

Can this be done over the network or does it need to be done via the serial console?  I SSH'd in, typed "configure" as my first command, and the AP responded:AP58f3.9cc4.9df4>configure                 ^% Invalid input detected at '^' marker. So I did...