About gianfrancobarile2

gianfrancobarile2 · 11-14-2014

Hello thereI configured the UCS server profile to boot from SAN, creating an hba with a WWN and LUN ID = 0when I install operating system booting the blade from a virtual cd of VMware 5.5u2, it found as disk the LUN0, the installation complete proper...

gianfrancobarile2 · 11-18-2014

hi wdeyI don't have access to the storage devices, only ask and try to obtain.

gianfrancobarile2 · 11-17-2014

when I install esx it show the following values60:06:01:60:20:45:34:00_7e:ec:53:b6:39:6b:e4:11If I try to set into boot SAN WWN port value 60:06xxx, it enable to save the value.if I try the 7e:ec:xxxx it doesn't enable to save the value.LUNid set is ...

gianfrancobarile2 · 11-17-2014

Hi wdeypwwn set in the primary and secondary boot profile is not the storage controller value.could be this the problem ?

gianfrancobarile2 · 11-17-2014

Hi wdey,thank you for your reply.fabric is set in end host mode and zoning is disabled.the only dubt is on the WWN value that I set in the primary and secondary boot.I see values start from 50:xx:xx... not seems to be UCS values. Instead I used the W...

gianfrancobarile2 · 11-14-2014

hisituation appears to be improved, but not solved.I renamed in the profile the hba name as used in the hba list.when the blade boot, now it show two msg (boot_fc image), then show that adapter bios is disabled (where is this in the profile ?) so no ...

Member Since	‎11-14-2014 12:48 AM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	7

User Statistics

User Activity

Unable to boot from SAN, despite ESX 55u2 is installed on a LUN0 properly

hi wdeyI don't have access to

when I install esx it show

Hi wdeypwwn set in the

Hi wdey,thank you for your

hisituation appears to be