Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have configured a firewall port as a port trunk and I need to configure GigabitEthernet on on 3702E AP as port trunk as well.Documentation is not of much help and I could not find any similar example on the Internet.My scenario is below: 1. My ...
I have a Cisco Aironet 3702E and I want to configure it as standalone unit in my network. This AP is a brand new and has not been deployed in a network and has not been controlled by an AC previously. I have tried to find out how to enable HTTP on th...
1. Trunk vs. AccessI guess I will use your recommendation and I will configure it as access. 2. This office is on a very low budget. There are only 10 employees and hence management is very tight. There won't be any extra AP's or switches. AP will be...
Many thanks. 1. If you want to use vlan20 in AP config then you have to create subinterfaces on your AP radio & ethernet interfacesI have to adhere to desire rule. Design says that to have to use vlan 20.You mean something like below: ap# configure ...
Hi,What do you think of below conf?Kind regards,Sam ! Configuration change 22 Nov 2014 by samversion 15.3no service padservice timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname KCAP!!logging rate-l...
Hi, One more thing DHCP is configured ion the firewall for VLANIF20. For AP I have reserved IP 10.2.2.2 and MAC locked it. Is there anything else I need to think about? Many thanks. Kind regards,Sam
Hi, Many thanks for your answer. 1. Is it not better to keep the port as port trunk rather than port access? I will define a native VLAN on AP and hence the VLAN ID should be the same on both side of the trunk.2. I have not enough switches. I have o...